Troubleshooting guide

Lab Exercise: Customized Report Design
Adding a Calibration Curve
139
Adding a Calibration Curve
1) Click on the blue triangle found between the General section and the Footer.
The triangle will change from blue to red.
2) Pull down the Edit menu and select New Section, Cal. Compounds.
3) Drag the Cal. Compounds borders to create free white space in this new
section.
4) Click on the Graphics Tool.
5) Draw in a rubber band box for the calibration table.
6) When the New Element panel is displayed, select Calibration Curve, then
OK. OK the Set-up panel as well.