Technical data

APPLy Commands 3
U2761A Programmer’s Reference 35
APPLy:RAMP
Syntax
APPLy:RAMP [<frequency> [,<amplitude> [,<offset>] ]]
This command outputs a Ramp wave with the specified frequency,
amplitude, and DC offset. The waveform is output as soon as the
command is executed.
Parameters
Remark
This command overrides the current symmetry setting and automatically
sets to the default value of 100%.
Example
The following command sets the output frequency to 10 kHz, output
amplitude to 1 Vpp, and output offset to 0 V.
APPL:RAMP 10000, 1 VPP, 0
Item Type Range of values Default value
frequency Numeric 1 μHz to 200 kHz 1 kHz
amplitude Numeric • 40 mVpp to 5 Vpp (Into 50 Ω load)
• 80 mVpp to 10 Vpp (Into open circuit)
1 Vpp
offset Numeric • ±2.48 V (Into 50 Ω load)
• ±4.96 V (Into open circuit)
0 V
APPL :RAMP space frequency , amplitude , offset