Technical data

17 Factory Default Settings
158 U2761A Programmer’s Reference
The factory default settings in the following table are used when the
U2761A is powered on.
Sending the *RST command will reset the U2761A to its factory default
state.
Tabl e 17-1 Factory default settings
Features Factory default settings
Output configuration
Function Sine wave
Frequency 1 kHz
Amplitude 1 Vpp
Offset 0 V
Voltage (High/Low) 0.5 V/–0.5 V
Output unit Vpp
Duty cycle 50%
Symmetry 100%
Output state Off
Output termination 50 Ω
Pulse
Period 1 ms
Pulse hold Pulse width
Pulse width 500 μs
Duty cycle 50%
Modulation
Carrier waveform (AM, FM, PM) 1 kHz Sine wave
Modulating waveform (AM, FM) 100 Hz Sine wave
Modulating waveform (PM) 10 Hz Sine wave
AM depth 100%