Technical data

16 Error Messages
148 U2761A Programmer’s Reference
–222 Data out of range; amplitude; value clipped to upper limit
The waveform amplitude has been limited to an upper boundary
–222 Data out of range; offset; value clipped to lower limit
The offset voltage has been limited to a lower boundary
–222 Data out of range; offset; value clipped to upper limit
The offset voltage has been limited to an upper boundary
–222 Data out of range; HIGH value; value clipped to lower limit
The high voltage has been limited to a lower boundary
–222 Data out of range; HIGH value; value clipped to upper limit
The high voltage has been limited to an upper boundary
–222 Data out of range; LOW value; value clipped to lower limit
The low voltage has been limited to a lower boundary
–222 Data out of range; LOW value; value clipped to upper limit
The low voltage has been limited to an upper boundary
–222 Data out of range; duty cycle; value clipped to lower limit
The Square wave duty cycle is limited to 20% by the U2761A hardware
–222 Data out of range; duty cycle; value clipped to upper limit
The Square wave duty cycle is limited to 80% by the U2761A hardware
–222 Data out of range; duty cycle limited by frequency; value clipped to lower limit
The Square wave duty cycle is limited to 40% when the frequency is greater than 10 MHz
–222 Data out of range; duty cycle limited by frequency; value clipped to upper limit
The Square wave duty cycle is limited to 60% when the frequency is greater than 10 MHz
–222 Data out of range; ramp symmetry; value clipped to lower limit
The ramp symmetry is limited to a lower boundary of 0.0% by the U2761A hardware
–222 Data out of range; ramp symmetry; value clipped to upper limit
The ramp symmetry is limited to an upper boundary of 100.0% by the U2761A hardware
–222 Data out of range; load; value clipped to lower limit
The output load is limited to a lower boundary of 1 Ω by the U2761A hardware
Tabl e 16-2 Execution errors (continued)