Technical data

Error Messages 16
U2761A Programmer’s Reference 147
–221 Settings conflict; PSK turned off by selection of other mode or modulation
The U2761A will allow only one modulation or sweep mode to be enabled at the same time
–221 Settings conflict; sweep turned off by selection of other mode or modulation
The U2761A will allow only one modulation or sweep mode to be enabled at the same time
–221 Settings conflict; 10MHz reference connector used by phase output
If you have enabled the output 10 MHz reference signal, the U2761A automatically disables the external
phase source. The 10 MHz reference connector cannot be used for both operations at the same time.
–221 Settings conflict; phase output disabled by phase external
When the external phase source is selected, the output 10 MHz reference signal cannot be enabled. The
10 MHz reference connector cannot be used for both operations at the same time.
–222 Data out of range; sine frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary due to the selection of the Sine waveform
function
–222 Data out of range; square frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary due to the selection of the Square
waveform function
–222 Data out of range; user frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary due to the selection of the Arbitrary
waveform function
–222 Data out of range; pulse frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary due to the selection of the Pulse
waveform function
–222 Data out of range; ramp frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary due to the selection of the Ramp
waveform function
–222 Data out of range; frequency; value clipped to lower limit
The waveform frequency has been limited to a lower boundary
–222 Data out of range; frequency; value clipped to upper limit
The waveform frequency has been limited to an upper boundary
–222 Data out of range; amplitude; value clipped to lower limit
The waveform amplitude has been limited to a lower boundary
Tabl e 16-2 Execution errors (continued)