Technical data

15 CONFigure Command
138 U2761A Programmer’s Reference
CONFigure:SSI
Syntax
CONFigure:SSI {NONE|MASTer|SLAVe}, (@<address>[,<address>])
This command sets the synchronization status (master/slave) when used in
the U2781A modular instrument chassis. The master/slave mode forces the
U2761A trigger source to Simultaneous Synchronization Interface (SSI).
This command is only operational when used in the U2781A chassis.
CONFigure:SSI?
This query returns the synchronization status as NONE, MAST, or SLAV,
and the corresponding address.
Parameters
Remarks
• Address is not required to be specified for CONFigure:SSI NONE.
• In the master mode, the U2761A sends the SSI signal to the slave unit
via the U2781A trigger bus. In the slave mode, the U2761A will receive
the signal from the master unit and begin synchronization.
• For more information on the SSI, refer to the U2781A USB Modular
Instrument Chassis User’s Guide.
Item Type Range of values Default value
mode Discrete NONE|MASTer|SLAVe NONE
address Numeric 0 to 7 0
spaceCONF NONE
MAST
SLAV
:SSI , @address , address( )