Technical data

9 Triggering Commands
100 U2761A Programmer’s Reference
OUTPut:TRIGger:SLOPe
Syntax
OUTPut:TRIGger:SLOPe {POSitive|NEGative}
This command sets the rising or falling edge for the “trigger out” signal at
the beginning of the sweep. When enabled using the
OUTPut:TRIGger[:STATe] command, a TTL- compatible Square waveform
with the specified edge is output from the Trig Out connector at the
beginning of the sweep.
OUTPut:TRIGger:SLOPe?
This query returns the selected trigger slope as POS or NEG.
Parameter
Remarks
• When the Immediate (internal) trigger source is selected, the U2761A
outputs a Square waveform with a 50% duty cycle from the Trig Out
connector at the beginning of the sweep. The period of the waveform is
equal to the specified sweep time.
• When the Bus (software) trigger source is selected, the U2761A outputs
a pulse from the Trig Out connector at the beginning of each sweep.
Item Type Range of values Default value
slope Discrete POSitive|NEGative POSitive
OUTP :TRIG space:SLOP POS
NEG
?