Technical data

8 Frequency Sweep Commands
94 U2761A Programmer’s Reference
[SOURce:]SWEep:STATe
Syntax
[SOURce:]SWEep:STATe {0|OFF|1|ON}
This command disables or enables the sweep mode.
[SOURce:]SWEep:STATe?
This query returns the sweep state as 0 if the sweep mode is disabled, or
1 if the sweep mode is enabled.
Parameter
Remark
The U2761A does not allow the sweep mode to be enabled at the same
time that any modulation mode is enabled.
Examples
The following command enables the sweep mode.
SWE:STAT ON
The following query returns the sweep state.
SWE:STAT?
Typical response:
1
Item Type Range of values Default value
state Boolean 0|OFF|1|ON 0
SOUR : SWE space
?
0|OFF
1|ON
:STAT