User's Manual

Performing Tests

Full Site Test (FCC)

Chapter 4

O:\Manuals\E6385A_Amps\Book\perftst.fm

Parameters and Specifications Used

The following parameters and specifications are used when running this test. See

Chapter 5, “Reference,” on page 95 for descriptions of the parameters and specifications.

Parameters:

• 1. Adjust TX Power [0=no 1=on fail 2=always]

• 3. GN Power Output [0=meas 1=spec 2=blnk]

• The TX Coupling factor for the associated antenna(s) listed in the frequency plan

must be entered. This is done in parameters 22 through 28.

• 30. TX Test Port Cable Loss

Specifications (Pass/Fail Limits):

This test uses all specifications described in “Specifications (Pass/Fail Limits)” on page

124.

Select and Run the Test

Select and run the Full Site Test (FCC) as follows:

Step 1. Create a frequency plan for the radios to be tested (see “Defining a Frequency Plan” on

page 43).

Step 2. From the Lucent AMPS Test Main Menu screen, select the Test Selections field. The

Test Software will display the Test Selections Menu screen.

Step 3. Select the Full Site Test (FCC) field.

Step 4. Connect the Test Set to the Base Station as shown in the on-screen prompts.

Step 5. Press the

k1 [Proceed] key.

Review the Results

The Test Software will display test results for each radio as it tests. It provides prompts

at the top of the display to indicate the measurement or action currently being

performed. See Figure 4-4.