User's Manual

Reference
Parameters
Chapter 5
121
Reference
17. MSC BTS Type [1=Series II 2=M 3=MM]
Enter the selection to specify the type of Base Station to be tested.
• If you select 1, indicates to the Test Software that the Base Station to be tested is
of the Series II type.
• If you select 2, indicates to the Test Software that the Base Station to be tested is
of the Series M type.
• If you select 3, indicates to the Test Software that the Base Station to be tested is
of the Series MM type.
18. MSC Cell Site Number [444 Max]
Enter the number of the cell site at which testing is to be performed.
19. MSC ECP Number
Enter the number of the ECP that controls the cell site at which testing is to be
performed.
20. MSC Require CP INH at Ant Port [1=Yes]
Enter the selection to determine whether the entire cell site or the specific sector is to
be taken out of service.
• If you select 1, all call processing will be inhibited, which takes the entire cell site
out of service for testing at the TX antenna ports.
• If you select 0, only the sector that is associated with the specific antenna port at
which testing is to be performed will be taken out of service.
NOTE When testing at the TX Antenna port, always verify that no radios are transmitting on
the antenna at which testing is to be performed before disconnecting the antenna.
21. TX Antenna Port Cable Loss
Enter the value of the cable loss in testing from the TX Antenna port. If you do not
know this value, use the TX Antenna Port Cable Calibration function of the Test
Software to measure it. See “TX Antenna Port Cable Calibration” on page 84.
22. TX Coupling Factor [ANT 0]
Enter the value of coupling factor for the Base Station TX Test Port for the specified
antenna.
23. TX Coupling Factor [ANT 1]
Enter the value of coupling factor for the Base Station TX Test Port for the specified
antenna.
24. TX Coupling Factor [ANT 2]
Enter the value of coupling factor for the Base Station TX Test Port for the specified
antenna.
25. TX Coupling Factor [ANT 3]
Enter the value of coupling factor for the Base Station TX Test Port for the specified
antenna.