User's Manual

General Programming Aspects

Programming Recommendations



It is recommended to test a new setting that will be programmed on

the instrument by setting it up manually.

Enable the outputs so that the instruments error check system is on

and possible parameter conflicts are immediately displayed.

When you have found the correct setting, then use this to create the

program. In the program it is recommended to send the command for

enabling outputs (for example, :

OUTPut ON

) as the last command.



Selftest of the instrument can be invoked by the common command

*TST



If it is important to know whether the last command is completed,

then send the common command

*OPC?