User's Manual

Manual Updates
The following information is provided to document the differences
between front panel operation of the LXI-compliant units and the
pre-LXI units.
LXI-compliant units
(see page 10 for additional details)
Pre-LXI units
OCP/488 LAN OUT ON
DC AMPS CURRENT
10
11
12
9
CC
OCP REM OUT ON
DC AMPS CURRENT
10
11
12
9
CC
9 – LAN
button
View address: Press LAN to view the
IP and Ethernet address.
Reset address: Press and hold the
LAN button for three seconds.
Pressing the LAN button again while
the message “LAn rES” is displayed
resets the LAN configuration to the
factory-shipped settings.
9 – REM
button
Mode function: Press REM to put the
unit into local mode. This function is
not available in LXI compliant units.
Address function: Selects the GPIB
address. Press and hold the REM
button for three seconds to set the
address with the Voltage knob.
10 – LAN
indicator
When lit, indicates that the LAN has
been configured and is operating
normally. When blinking, identifies
the unit for which the indicator has
been set to blink by the unit’s Web
home page.
10 – REM
indicator
When lit, indicates that the unit is in
Remote mode. This function is not
available in LXI compliant units.
11 – OCP/488
button
Enable OCP: Press OCP/488 to turn
over-current protection (OCP) on.
Press again to turn OCP off.
Reset OCP: When an over-current
protection event occurs, press the
OUT ON button to enable the output
and re-arm over-current protection.
GPIB address: Press and hold the
OCP/488 button for three seconds to
set the address with the Voltage knob.
11 – OCP
button
Enable function: Press OCP/488 to
turn over-current protection (OCP) on.
Press again to turn OCP off.
Reset OCP: When an over-current
protection event occurs, press the
OUT ON button to enable the output
and re-arm over-current protection.
12 – OCP
indicator
When lit, indicates that over-current
protection is enabled or on.
12 – OCP
indicator
When lit, indicates that over-current
protection is enabled or on.