User's Manual

Messages Displayed During Menu Use
TOP OF MENU You pressed
¾ while on the “MENUS” level; this is the top
level of the menu and you cannot go any higher.
To turn off the menu, press
Shift Menu On/Off . To move across the choices on
a level, press
< or > . To move down a level, press
¿ .
MENUS
You are on the “MENUS” level. Press < or > to view the choices.
COMMANDS
You are on the “COMMANDS” level. Press < or > to view the
command choices within the selected menu group.
PARAMETER You are on the “
PARAMETER” level. Press < or > to view
and edit the parameter for the selected command.
MENU BOTTOM You pressed
¿ while on the “PARAMETER” level; this is the
bottom level of the menu and you cannot go any lower.
To turn off the menu, press
Shift Menu On/Off . To move up a level, press
¾ .
ENTERED The change made on the “
PARAMETER” level is saved. This is
displayed after you press
Enter (Menu Enter) to execute the command.
MIN VALUE The value you specified on the “
PARAMETER” level is too small for
the selected command. The minimum value allowed is displayed for you to edit.
MAX VALUE The value you specified on the “
PARAMETER” level is too large for
the selected command. The maximum value allowed is displayed for you to edit.
EXITING You will see this message if you turn off the menu by pressing
Shift Menu On/Off or Shift Cancel . You did not edit any values on the
“
PARAMETER” level and changes were NOT saved.
NOT ENTERED You will see this message if you turn off the menu by pressing
Shift Menu On/Off or Shift Cancel . You did some editing of parameters but
the changes were
NOT saved. Press Enter (Menu Enter) to save changes
made on the “
PARAMETER” level.
Chapter 3 Front-Panel Menu Operation
A front-panel menu tutorial
40