User's Manual

Chapter 1: Getting Started

• “Step 2. Choose the sampling mode” on page 16

• “Step 3. Format labels for the probed signals” on page 19

In the timing (asynchronous) or state (synchronous) sampling modes,

measurements will have these steps:

• “Step 4. Define the trigger condition” on page 22

• “Step 5. Run the measurement” on page 23

• “Step 6. Display the captured data” on page 24

In the eye scan sampling mode, measurements will have these steps:

• “Step 4. Select channels for the eye scan measurement” on page 26

• “Step 5. Set the eye scan range and resolution” on page 27

• “Step 6. Run the eye scan measurement” on page 28

• “Step 7. Display the captured eye scan data” on page 29

If you have previously saved a logic analyzer setup to a configuration

file, or if configuration files are included with an analysis probe, you

can load the configuration file to set up the logic analyzer and the

measurement.

Once you have made a logic analyzer measurement, the measurement

can be refined by repeating the measurement set up, run, and display

steps.

Next: “Step 1. Connect logic analyzer to the device under test” on

page 15