User's Manual

128
Chapter 4: Using the Logic Analyzer in Eye Scan Mode
Setting Up and Running Eye Scan Measurements
6. Select Sampling Positions... to open the Sampling Positions dialog. Select
the label you created and choose Expand to display all the signals (if it is
not already expanded).
7. Start your target system and select Run Eye Finder.
8. When Eye Finder completes its run, move the qualifier sampling position
to the right of the qualifier transition region at or to the right of the clock
position (t = 0). The sampling position is shown by the blue line in the
display.
NOTE: The sampling positions for data are not used by eye scan. They should be set
for correct state mode acquisitions.