User's Manual
Table Of Contents
- Title Page
- Table of Contents
- Documentation Overview
- 1 Safety Information
- 2 Getting Started
- Checking the Shipment
- Signal Generator Physical Characteristics
- Meeting Environmental and Electrical Requirements
- Configuring the MXG ATE
- Configuring the Display (N5181A/82A/83A Only)
- Configuring for Remote Control
- Ordering Accessories
- Proper Use and Cleaning
- Returning a Signal Generator to Agilent Technologies
- Contacting Agilent
- 3 Operation Verification
- 4 Regulatory Information
- Index
8 Agilent N5161A/62A/81A/82A/83A MXG Signal Generators Installation Guide
Getting Started
Configuring the MXG ATE
Figure 2-1 Web-Enabled MXG ATE
2
Note:
If you do not see this window, check to see if the window is hidden behind your browser
window or your web browser settings are set to block pop-ups. To use this feature, you need to
set your web browser to allow pop-ups for your instrument’s IP address.
Remote SCPI commands requires the Telnet feature on the computer. The Telnet feature is
available from a variety of sources. Some software updates can block (break) this Telnet
connection (e.g. Internet Explorer 7). When using Internet Explorer as a browser, only versions
<Internet Explorer 7 enable the Web-Enabled MXG SCPI feature.
To operate the signal generator, click the keys.
The Agilent MXG ATE supports LXI Class
B* functionality.
For more information
on the LXI standards, refer to
http://www.lxistandard.org/home.
*LXI Class B Compliance testing using
IEEE 1588-2008 not available at release.