Manual
Table Of Contents
- Agilent U2121A-101 RF Switch Driver Board
- Safety Symbols
- Environmental Conditions
- Regulatory Markings
- Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC
- Contents
- Introduction
- Standard Purchase Items Checklist
- Product at a Glance
- Connector Pins Configuration
- Installation Guide
- Supported Switches
- Product Characteristics and Specifications
- Maintenance
- Disassemble Procedure
- Ordering Info
- Appendix A: Control Instructions
- Appendix B: Y1157A Cable Assembly Instructions
24 U2121A-101 Operating Guide
Disassemble Procedure
The following steps shows the disassemble procedure of the RF switch
driver board from its casing.
1 Remove the two screws on either side of the board.
2 Remove the side panel from the casing.
U2931A Operating Guide.book Page 24 Tuesday, June 10, 2008 10:17 AM