Manual
Table Of Contents
- Agilent U2121A-101 RF Switch Driver Board
- Safety Symbols
- Environmental Conditions
- Regulatory Markings
- Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC
- Contents
- Introduction
- Standard Purchase Items Checklist
- Product at a Glance
- Connector Pins Configuration
- Installation Guide
- Supported Switches
- Product Characteristics and Specifications
- Maintenance
- Disassemble Procedure
- Ordering Info
- Appendix A: Control Instructions
- Appendix B: Y1157A Cable Assembly Instructions
U2121A-101 Operating Guide 23
Maintenance
1 Power off your device, unplug the DC power jack and remove the
RF switch driver board interface cable from your device.
2 Remove your device from the plastic casing.
3 Shake out any dirt that may have accumulated on the RF switch
driver board.
4 Wipe your RF switch driver board with a dry cloth and install the
plastic casing back in place.
U2931A Operating Guide.book Page 23 Tuesday, June 10, 2008 10:17 AM