Manual
Table Of Contents
- Agilent U2121A-101 RF Switch Driver Board
- Safety Symbols
- Environmental Conditions
- Regulatory Markings
- Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC
- Contents
- Introduction
- Standard Purchase Items Checklist
- Product at a Glance
- Connector Pins Configuration
- Installation Guide
- Supported Switches
- Product Characteristics and Specifications
- Maintenance
- Disassemble Procedure
- Ordering Info
- Appendix A: Control Instructions
- Appendix B: Y1157A Cable Assembly Instructions
10 U2121A-101 Operating Guide
Installation Guide
Follow the step- by- step instructions shown in the following flowchart
to get started with the preparations and installations of your Agilent
U2121A- Based RF Switch Driver Software.
NOTE
You need to install the IVI-COM driver if you are going to use the U2121A- 101
with Agilent VEE Pro, LabVIEW, or Microsoft
®
Visual Studio
®
.
A. Check your system
B. Install prerequisites and software
C. Connect the hardware solution to your PC
D. Launch the Agilent U2121A-Based RF
Switch Driver Software
U2931A Operating Guide.book Page 10 Tuesday, June 10, 2008 10:17 AM