User manual

46 Agilent 1260 Infinity High Performance Autosampler User Manual

3 Installing the Autosampler

Flow Connections to the Autosampler

1 Open the front cover by pressing the button on the right side of the

module.

2 Install the capillary from the pump outlet into the port 1 of the

injection valve.

3 Install the capillary from the port 6 of the injection valve to the TCC.

Parts required Description

System

Capillaries and tubing from Accessory Kit.

Preparations Autosampler is installed in system.

NOTE

In an Agilent 1260 Infinity Liquid Chromatograph, the Autosampler is located between a

Pump (above) and the Thermostatted Column Compartment (below), see “Optimizing the

Stack Configuration” on page 35

WARNING

Toxic, flammable and hazardous solvents, samples and reagents

The handling of solvents, samples and reagents can hold health and safety risks.

➔ When working with these substances observe appropriate safety procedures (for

example by wearing goggles, safety gloves and protective clothing) as described in

the material handling and safety data sheet supplied by the vendor, and follow good

laboratory practice.

➔ The volume of substances should be reduced to the minimum required for the

analysis.

➔ Do not operate the instrument in an explosive atmosphere.

NOTE

The Autosampler can only be operated with the front and side covers closed.