User manual

Agilent 1260 Infinity High Performance Autosampler User Manual 45

Installing the Autosampler

3 Connect the power cable to the power connector at the rear of the

module.

Figure 13 Rearview of Autosampler

4 Connect the CAN cable to other Agilent 1260 Infinity modules.

5 Connect the APG remote cable (optional) for non- Agilent instruments.

6 Turn on the power by pushing the button at the lower left hand side of

the module.

The power button stays pressed in and the status LED should be green.

NOTE

When the line power button stands out and the green light is off, the module is turned off.

NOTE

The module was shipped with default configuration settings. For changing these settings,

refer to section Setting the 8-bit configuration switch.