User manual

44 Agilent 1260 Infinity High Performance Autosampler User Manual
3 Installing the Autosampler
Installing the Autosampler
Installing the Autosampler
1 Place the Autosampler in the stack, see “Optimizing the Stack
Configuration” on page 35.
2 Ensure the power switch on the front of the module is OFF (switch
stands out).
Parts required Description
Autosampler
Power cord
Hardware required Other cables see below and section “Cable Overview” on page 156
Software required ChemStation and/or Instant Pilot G4208A with the appropriate revisions, see Ta b l e 2 on page 28
WARNING
Module is partially energized when switched off, as long as the power cord is
plugged in.
Repair work at the module can lead to personal injuries, e.g. shock hazard, when the
cover is opened and the module is connected to power.
➔ Make sure that it is always possible to access the power plug.
➔ Remove the power cable from the instrument before opening the cover.
➔ Do not connect the power cable to the Instrument while the covers are removed.
CAUTION
"Defective on arrival" problems
If there are signs of damage, please do not attempt to install the module. Inspection by
Agilent is required to evaluate if the instrument is in good condition or damaged.
➔ Notify your Agilent sales and service office about the damage.
➔ An Agilent service representative will inspect the instrument at your site and
initiate appropriate actions.