User manual

Agilent 1260 Infinity High Performance Autosampler User Manual 183

Hardware Information

Setting the 8-bit Configuration Switch

The 8- bit configuration switch is located at the rear of the module.

This module does not have its own on- board LAN interface. It can be

controlled through the LAN interface of another module, and a CAN

connection to that module.

Figure 35 Configuration switch (settings depend on configured mode)

All modules without on- board LAN:

• default should be ALL DIPS DOWN (= best settings)

• Bootp mode for LAN and

• 19200 baud, 8 data bit / 1 stop bit with no parity for RS- 232

• DIP 1 DOWN and DIP 2 UP allows special RS- 232 settings

• for boot/test modes DIPS 1+2 must be UP plus required mode

Switch settings provide configuration parameters for serial communication

protocol and instrument specific initialization procedures.

NOTE

For normal operation use the default (best) settings.