Technical information

5
Connecting the Ethernet and Trigger Cables
Connecting the Ethernet Cables
28 Agilent 1200 Series Getting Connected Guide Thermo Scientific
Connecting the Ethernet Cables
Y To connect the Ethernet communication cable to an Agilent 1200 Series LC
1. Connect a category 5, shielded Ethernet cable from the Agilent LAN interface to the
Ethernet switch (Figure 20).
2. Connect an Ethernet cable from the Ethernet switch to the network card dedicated to the
LC/MS system (typically network interface card number 3).
Figure 20. Ethernet connections
CAUTION To ensure compliance with safety and EMC regulations, use the Ethernet
cables supplied in the Ethernet Communication kit or category 5, shielded Ethernet
cables no longer than 3 m (10 ft) in length.
REMOTE RS-232
CONFIG
ANALOG
CANCAN
Agilent Technologies
Activity
Speed
G1369 LAN Interface
LANUSB
REMOTE
RS-232
CANCAN
CONFIG
REMOTE FLASH
PCMCIA
ANALOG
1
ANALOG
2
Surveyor
MS
CONFIG
Data system computer
(subject to change)
Ethernet switch
Category 5
shielded
Ethernet cables
Agilent LAN interface board
model G1369A
OR
On-board LAN interface
port
Initialization switches for
on-board LAN interface
configured to use a
stored IP address