Technical information

3
Setting Up the Xcalibur Instrument Configuration
Specifying the Configuration Options for the Agilent LC System
24 Agilent 1200 Series Getting Connected Guide Thermo Scientific
Figure 17. Agilent 1200 G1315 DAD dialog box with the parameters for G1315B
2. On the General page, do the following:
• In the Stack IP Address box, make sure that the IP address is correct for your system
setup. See Tabl e 3 on page 15.
• In the Module Name list, select the model number of the detector.
The model number is stamped on the front panel, lower-right corner of the device
(see Figure 13 on page 19).
Step 4: Closing the Xcalibur Instrument Configuration Program
Before opening the Xcalibur data system, close the Xcalibur Instrument Configuration
program. You cannot have both programs open at the same time.
Y To close the Xcalibur Instrument Configuration program
When you finish specifying the configuration options for the Agilent LC system, click
Done to close the Xcalibur Instrument Configuration program.
This check box is not
available for model number
G1315C or G1315D.
172 . 16 . 0 . 102
Note The TCP/IP settings are shared by all Agilent 1200 LC modules in the
stack. Changing the value of a setting for one module in the Instrument
Configuration dialog box changes the value of that setting for all modules in the
stack.