Technical information

3
Setting Up the Xcalibur Instrument Configuration
Specifying the Configuration Options for the Agilent LC System
Thermo Scientific Agilent 1200 Series Getting Connected Guide 23
2. On the General page, do the following:
• In the Stack IP Address box, make sure that the IP address is correct for your system
setup. See Tabl e 3 on page 15.
• In the Module Name list, select the model number of the TCC.
The model number is stamped on the front panel, lower-right corner of the device
(see Figure 13 on page 19).
3. Click OK to save the settings and close the dialog box.
Configuring the Agilent 1200 Series Diode Array Detector
Use the Agilent 1200 G1315 DAD dialog box to specify the model number of the diode array
detector.
Y To specify the configuration options for the diode array detector
1. Under Configured Devices, double-click .
The Agilent 1200 G1315 DAD dialog box appears (see Figure 17).
Note The TCP/IP settings are shared by all Agilent 1200 LC modules in the
stack. Changing the value of a setting for one module in the Instrument
Configuration dialog box changes the value of that setting for all modules in the
stack.
Note You cannot install an external contact board in the G1315C or G1315D
versions of the Agilent 1200 Series DAD.