Technical information

3
Setting Up the Xcalibur Instrument Configuration
Specifying the Configuration Options for the Agilent LC System
Thermo Scientific Agilent 1200 Series Getting Connected Guide 21
Figure 15. Agilent1200 G1312 Bin Pump dialog box
3. On the General page, make the appropriate selections and entries.
• If you have installed the external contact interface board in the pump, select the
Contact board installed check box.
• In the Stack IP Address box, make sure that the IP address is correct for your system
setup. See Tabl e 3 on page 15.
• In the Serial Number box, type the serial number of the Agilent pump.
Because you can configure two pumps per stack, you must type the correct serial
number to initiate communication between the pump and the Xcalibur data system.
• In the Module Name list for the binary pump, select the model number that is
stamped on the front panel, lower-right corner of the Agilent module (see Figure 13
on page 19).
Make sure you enter the correct
serial number in this box, so
that Xcalibur can communicate
with the pump.
172 . 16 . 0 . 102
DE60555493
Note When you select the select the Contact board installed check box, the
Timed Events page appears in the Instrument Setup view for the pump. See
Chapter 6, “Setting Up the Instrument Method to Trigger Data Acquisition.”
Note The TCP/IP settings are shared by all Agilent 1200 LC modules in the
stack. Changing the value of a setting for one module in the Instrument
Configuration dialog box changes the value of that setting for all modules in the
stack.