Technical information

3
Setting Up the Xcalibur Instrument Configuration
Specifying the Configuration Options for the Agilent LC System
20 Agilent 1200 Series Getting Connected Guide Thermo Scientific
5. On the Tray & Thermostat page, make the appropriate selections:
• Under Metering Device, make the appropriate size selections from the Syringe, Seat
Capillary, and Loop Capillary lists.
• Under Tray Combination, select the tray type that you plan to use. For information
on the vial and tray locations for the available tray combinations, see Chapter 7, “Vial
and Well Locations for the Available Tray Types.”
• If the Agilent stack has a thermostat module (G1330B), select the Thermostat
control installed check box.
6. Click OK to save the settings and close the dialog box.
Configuring the Agilent 1200 Series Pump
Use the configuration dialog box for the pump to specify its serial number and model
number. For the binary pump, you can also specify whether the system has the optional
selection valve installed.
Y To specify the configuration options for the pump
1. Under Configured Devices, double-click the button for the Agilent 1200 Series pump:
• For the binary pump, double-click .
• For the quaternary pump, double-click .
The Agilent 1200 G1312 Bin or Agilent 1200 G1311 Quat dialog box appears.
2. Click the General tab.
The General page appears. Figure 15 shows the General page for the binary pump.
IMPORTANT Be sure to enter the correct serial number when you configure the pump;
otherwise, the Xcalibur data system cannot communicate with the pump.