Technical information

3
Setting Up the Xcalibur Instrument Configuration
Specifying the Configuration Options for the Agilent LC System
18 Agilent 1200 Series Getting Connected Guide Thermo Scientific
Figure 12. Agilent1200 HiP-ALS dialog box with the stack IP address set to the default
3. On the General page, make the appropriate selections:
• If you have installed the external contact interface board in the autosampler, select the
Contact board installed check box.
• In the Stack IP Address box, make sure that the IP address is correct for your system
setup. See Tabl e 3 on page 15.
• In the Module Name list, select the model number that is stamped on the front
panel, lower-right corner of the Agilent device (see Figure 13).
172 . 16 . 0 . 102172 . 16 . 0 . 102
Note When you select the Contact Board Installed check box, the Timed Events
page appears in the Instrument Setup view for the autosampler. See Chapter 6,
“Setting Up the Instrument Method to Trigger Data Acquisition.”
Note The TCP/IP settings are shared by all Agilent 1200 LC modules in the
stack. Changing the value of a setting for one module in the Instrument
Configuration dialog box changes the value of that setting for all modules in the
stack.