Technical information

Thermo Scientific Agilent 1200 Series Getting Connected Guide 15
3
Setting Up the Xcalibur Instrument Configuration
This chapter describes how to add the Agilent 1200 Series devices to the Xcalibur instrument
configuration and specify their configuration options.
The Agilent 1200 Series LC System IP Address
When you specify the configuration options for the Agilent 1200 Series LC system, you
specify the IP address for the entire stack.
You enter the stack IP address for the Agilent 1200 Series LC system when you configure the
devices. Once you enter the stack IP address for one device, this IP address appears in the
configuration dialog box for each connected device.
Tabl e 3 lists the IP address for an LC/MS system with a Thermo Scientific mass spectrometer.
Contents
• The Agilent 1200 Series LC System IP Address
• The Contact Closure Board
• Specifying the Configuration Options for the Agilent LC System
IMPORTANT To maintain stable communication with the Xcalibur data system, the
Agilent LAN interface must be set up to use a stored IP address. For information on
configuring the Agilent LAN interface to use a stored IP address, see Chapter 2, “Setting
Up the LAN Interface.”
Table 3. IP addresses for an Agilent 1200 Series LC/Thermo Scientific MS system
System Setup IP Address
LC/MS system with a Thermo Scientific mass spectrometer 172.16.0.102