Technical information

2
Setting Up the LAN Interface
Step 3: Setting the Stored TCP/IP Address with a Telnet Session
Thermo Scientific Agilent 1200 Series Getting Connected Guide 13
d. Click OK to save the settings and close the Internet Protocol (TCP/IP) Properties
dialog box.
Figure 11 shows the appropriate IP address for the network card in the data system
computer.
Figure 11. Internet Protocol (TCP/IP) Properties dialog box
e. Exit the Control Panel.
After setting the stored IP address and subnet mask for the Agilent LAN interface, you are
ready to set up the LAN interface initialization switches so that the LAN interface uses the
stored IP address. See “Step 4: Setting Up the LAN Interface to Use a Stored IP Address” on
page 14.