Technical information

2
Setting Up the LAN Interface
Step 3: Setting the Stored TCP/IP Address with a Telnet Session
Thermo Scientific Agilent 1200 Series Getting Connected Guide 11
The Telnet session with the Agilent LAN interface begins (Figure 9).
Figure 9. Beginning of a Telnet session with the Agilent LAN interface
5. Set the IP address for the Agilent LAN interface as follows:
a. At the prompt (Figure 9), type a slash (/), and then press ENTER to display the
current settings of the LAN interface. Figure 10 shows a Telnet session with the LAN
Status Page displayed.
Telnet commands are listed in the following table.
Prompt
line
Table 2. Telnet commands
Value Description
/ Displays current settings.
ip <x.x.x.x> Sets new IP address.
sm <x.x.x.x> Sets new subnet mask address.
gw <x.x.x.x> Sets new gateway address.
quit Saves changes and exits the shell (for the G1369A LAN card).
exit Exits shell without saving changes (for the G1369A LAN card)
Saves changes and exits the shell (for the on-board LAN
interface).