Technical information

Checking the Firmware Versions of the Agilent Devices

Checking the Firmware Versions with the Agilent Instant Pilot

2 Agilent 1200 Series Getting Connected Guide Thermo Scientific

Checking the Firmware Versions with the Agilent Instant Pilot

You can use the Agilent Instant Pilot to check the firmware versions of the Agilent 1200 Series

modules to ensure their compatibility with the device drivers provided with LC Devices.

Y To check the firmware version of an Agilent 1200 Series module

1. Make sure that the Agilent 1200 Series modules are connected by CAN communication

cables, that all the modules are turned on, and that the Agilent 1200 Series Instant Pilot is

connected.

For instructions on how to connect the CAN cables, refer to the Agilent 1200 Series LC

reference manuals.

2. From the Welcome screen of the Instant Pilot, press the Details key (see Figure 1).

Figure 1. Welcome screen

The System Info screen appears. The System Info screen contains information about the

firmware versions of the configured system modules.

3. Check the firmware versions against those listed in Tabl e 1 on page 1.

Esc

Sequence

Status

Logbook

10:00

Select a button to continue

Display

Control

Details

Welcome

Quat Pump

Autosampler

Col Comp

Method

Agilent Technologies

456

0.~

Start Stop