User manual

G1369A LAN Interface User Manual 33
Getting Started 2
Manual configuration
5 Change the IP address (in this example 134.40.24.158) and type “/” to list
current settings.
Figure 24 Telnet - Change IP settings
6 When you have finished typing the configuration parameters, type:
quit and press [Enter] to store the configuration parameters
or
exit and press [Enter] to exit without storing parameters.
If the Initialization Mode Switch is changed now to “Using Stored” mode,
the instrument will take the stored settings when the module is re-booted.
In the example above it would be 134.40.24.158 on QUIT and 134.40.24.160
on EXIT.
change of TCP/IP setting
last user change (not active yet, requires mode “Using
Stored” and re-start)
stored TCP/IP settings in non-volatile memory
active TCP/IP settings
Initialization mode is Bootp
The connected PC/Bootserver is 134.40.24.184