User manual

32 G1369A LAN Interface User Manual
2Getting Started
Manual configuration
4 Use the “/” and press Enter to list the current settings.
Figure 23 Telnet - Current settings in Bootp mode
Table 7 Telnet Commands
Value Description
? displays syntax and descriptions of commands
/ displays current settings
ip <x.x.x.x> sets new ip address
sn <x.x.x.x> set new subnet mask
gw <x.x.x.x> sets new default gateway
quit saves changes and exit shell
exit exits shell without saving changes
NOTE
Any time during the Telnet session you can type “?” then press [Enter] to view available
configuration parameters, the correct command format, and a list of additional commands
to display.
information about the card
Product id, firmware revision (A.xx.xx are released
versions), MAC address, initialization mode
stored TCP/IP settings in non-volatile memory (not
visible if equal to active TCP/IP settings)
active TCP/IP settings
connected to PC with controller software (e.g. Agilent
ChemStation), here not connected
Initialization mode is Bootp
The connected PC/Bootserver is 134.40.24.184