User manual

G1369A LAN Interface User Manual 31
Getting Started 2
Manual configuration
With Telnet
Whenever a TCP/IP connection to the card is possible (TCP/IP parameters set
by any method), the parameters may be altered by opening a Telnet session.
1 Open the system (DOS) prompt window by clicking on Windows START
button and select “Run...”. Type “cmd” and press OK.
2 Type the following at the system (DOS) prompt:
c:\>telnet <IP address>
Figure 21 Telnet - Starting a session
where <IP address> may be the assigned address from a Bootp cycle, a
configuration session with the Handheld Controller (G1323A/B), or the
default IP address (see “Configuration switches” on page 19).
When the connection was established successfully, the card responds with
the following:
Figure 22 A connection to the module is made
3 To change a parameter follows the style:
parameter value
for example: ip 134.40.24.230
then press [Enter], where parameter refers to the configuration parameter
you are defining, and value refers to the definitions you are assigning to
that parameter. Each parameter entry is followed by a carriage return.