User manual

16 G1369A LAN Interface User Manual
2Getting Started
Installing and cabling the LAN Interface
2 Note the MAC (Media Access Control) address for further reference. The
MAC or hardware address of the LAN Interface is a world wide unique
identifier. No other network device will have the same hardware address.
The MAC address can be found on a label on the card (see Figure 6 on
page 15).
Figure 7 MAC-Label
3 Turn off instrument line power or remove the power cord before installing
the LAN Interface.
4 On your instrument, identify the option slot for the MIO accessory card.
5 Remove any blank cover plates and ensure that the slot is empty.
Figure 8 Location of LAN Interface (e.g. 1100 series detector)
Part number of the LAN Interface, see page 44
Revision Code, Vendor, Year and Week of assembly
MAC address
Country of Origin
NOTE
If the module has the 1100 CAN modification board installed, it probably has a revision 1
mainboard and will not accept the LAN interface. Refer to “LAN Interface compatibility” on
page 12