User manual

G1369B LAN Interface User Manual 39
Getting Started 2
Manual Configuration
then press [Enter], where parameter refers to the configuration parameter
you are defining, and value refers to the definitions you are assigning to
that parameter. Each parameter entry is followed by a carriage return.
Table 8 Telnet Commands
Value Description
? displays syntax and descriptions of commands
/ displays current settings
ip <x.x.x.x> sets new ip address
sn <x.x.x.x> set new subnet mask
gw <x.x.x.x> sets new default gateway
quit saves changes and exit shell
exit exits shell without saving changes
NOTE
Any time during the Telnet session you can type “?” then press [Enter] to view available
configuration parameters, the correct command format, and a list of additional commands
to display.