User manual

26 G1369B LAN Interface User Manual
2Getting Started
LAN Interface Configuration
Link Configuration Selection
The LAN Interface supports 10 or 100 Mbps operation in full- or half-duplex
modes. In most cases, full-duplex is supported when the connecting network
device - such as a network switch or hub - supports IEEE 802.3u
auto-negotiation specifications.
When connecting to network devices that do not support auto-negotiation, the
LAN Interface will configure itself for 10- or 100-Mbps half-duplex operation.
For example, when connected to a non-negotiating 10-Mbps hub, the LAN
Interface will be automatically set to operate at 10-Mbps half-duplex.
If the card is not able to connect to the network through auto-negotiation, you
can manually set the link operating mode using link configuration switches on
the card.
Table 7 Link Configuration Switches
SW 1 SW 2 SW 3 SW 7 SW 8 Link Configuration
OFF - - OFF OFF speed and duplex mode determined by
auto-negotiation
ON OFF OFF OFF OFF manually set to 10 Mbps, half-duplex
ON OFF ON OFF OFF manually set to 10 Mbps, full-duplex
ON ON OFF OFF OFF manually set to 100 Mbps, half-duplex
ON ON ON OFF OFF manually set to 100 Mbps, full-duplex
1
2
345678
ON
NOTE
Compared to the G169A LAN Card, SW 7 and SW 8 must be always in OFF position on the G1369B
LAN Card, otherwise the selected modes are not working.