User manual

G1369B LAN Interface User Manual 25
Getting Started 2
LAN Interface Configuration
Since the default IP address is a so-called local address, it will not be routed by
any network device. Thus, the PC and the card must reside in the same subnet.
The user may open a Telnet session using the default IP address and change
the parameters stored in the non-volatile memory of the card. He may then
close the session, select the initialization mode “Using Stored”, power-on again
and establish the TCP/IP connection using the new parameters.
When the card is wired to the PC directly (e.g. using a cross-over cable or a
local hub), separated from the local area network, the user may simply keep
the default parameters to establish the TCP/IP connection.
NOTE
In the “Using Default” mode, the parameters stored in the memory of the card are not
cleared automatically. If not changed by the user, they are still available, when switching
back to the mode “Using Stored”.