User`s guide

Chapter 2 47
Installing the E5810A
Configuring the E5810A on a Local Network
Configuring the
E5810 for Enterprise
Network Operation
You can check or set E5810 configuration parameters using the E5810 Web
access that is accessed from your Web browser (Internet Explorer 6.0 or
greater). The steps to set E5810 configuration parameters are:
1 Display the Welcome Page. From your Web browser address line, type
‘http://<E5810 IP Address>’, where <E5810 IP Address> is
the IP address displayed on the E5810 front panel display. Then, press
the
Enter key to display the E5810 Welcome page.
For example, if the default IP address of 169.254.58.10 is displayed on
the E5810 front panel, typing
http://169.254.58.10 on your Web
browser address line and pressing
Enter displays the E5810 Welcome
page. The following figure shows a typical display.
2 Display the Current Configuration Page. From the Welcome page, click
the
View & Modify Configuration icon to display the Current
Configuration of E5810 LAN/GPIB Gateway
page