User`s guide

Connecting Instruments to LAN

Step 3: Connect Your Instruments

Example: Switch Connections (Site LAN)

This figure shows one way to connect instruments to a site LAN via an

Ethernet Hub or Switch.

Turn Power OFF. Remove power from the instruments.

Connect Instruments to Hub/Switch. If you use a hub or switch, use

standard CAT5 LAN cables to connect each instrument to the hub

or switch. See the hub/switch documentation for connections.

Turn Power ON. Apply power to the hub/switch (if not already ON) and

then to the instruments and verify proper power-on sequence. See the

instrument’s User’s Guide for instrument information.

Instrument Instrument Instrument

Ethernet Hub

or Switch

To LAN Port on

Instruments

To Site LAN

Instrument

Standard CAT5

LAN Cable