User`s guide

125
Troubleshooting Guidelines
Troubleshooting GPIB Interfaces
Check IO Libraries
Installation
1 GPIB Hardware Checks
Check Cables/
Connections/Power
Check for GPIB
Driver Files
Install Libraries (if GPIB
Already Installed)
Check IO Control
Operation
Check Device Manager
Typical Causes
Bad GPIB cables/connections
or power not ON for PC or
instruments.
Typical Causes
GPIB card drivers not installed
or GPIB card not properly
configured.
Typical Causes
Agilent IO Libraries not
installed or improper IO
Libraries configuration
Disable IO Config
Auto-Detection
Set 82350 Read/Write
Performance Mode
After Doing These Checks:
- If the cause is not identified,
see
GPIB Software Checks
- If the cause is identified as an
82350 hardware problem,
contact Agilent to return the
82350.
After Doing These Checks:
- If the cause is not identified,
see
Agilent IO Libraries Checks
- If the cause is identified, but the
problem cannot be fixed, contact
Agilent for support.
After Doing These Checks:
- If the cause is not identified
or the problem cannot be
fixed, contact Agilent for
support.
Check BIOS/Interrupts
Settings
2 GPIB Software Checks 3 IO Libraries Checks
Other Hardware Checks