User`s guide

1-6 Agilent 4155C/4156C VXIplug&play Driver User’s Guide, Edition 1
Installation
Installing 4155/4156 Driver
To Configure the Interface using Agilent I/O Library
After installing the IEEE 488 interface card and the Agilent I/O Library, configure
the interface. The procedure shown below is the easiest way to configure the
interface. First, execute I_O Config in the HP I_O Libraries folder. The I/O Config
window is displayed. See Figure 1-1.
1. Click Auto Add.
If the interface card is installed properly, I_O Config automatically detects the
hardware configuration. The default names for SICL and VISA are assigned and
listed, as shown in the Configured Interface list.
2. Click hpib7 GPIB0.
3. Click Edit to display the Configuration dialog box for the interface card.
If you find any conflicts in the dialog box, such as IRQ line, you may need to
change them manually. Normally you can exit without modifying the default
setup.
4. Click OK to exit. Reboot your PC to configure the interface.
Figure 1-1 To Configure the Interface using Agilent I/O Library
NOTE VISA Name is used by the VXIplug&play drivers to access the interface.



