Computer Accessories User Manual

Installing and Configuring the 82350 1
82350B Installation and Configuration Guide 25
2 Configure GPIB Card Parameters. When the
Agilent 82350 PCI GPIB Interface dialog box
appears, set the VISA interface ID, SICL
interface ID, Logical unit and GPIB address
values as required.
Also, verify that this is the System controller
for the GPIB to which it is attached (this is the
typical operating mode). (See the System
Controller discussion below.) Then, click the OK
button. Some guidelines to set these values
follow.
Figure 1-11 Configure GPIB card parameters
NOTE
Changes to certain properties of the 82350, including:
• GPIB address
• System controller flag
• SICL interface ID
• Logical unit
will not take effect until you reboot your PC. If you choose not to
reboot immediately, Connection Expert will display a warning icon
until you reboot.