Specifications

Getting Started 1
Multiport Power Meter Getting Started 17
Removing Optical Interfaces
1 Press the release levers on both sides of the quad-adapter to
release it from the front panel of the power meter.
2 You can now remove the optical connectors from the
quad-adapter.
Electrical Connectors
There are two BNC connectors on the rear panel of your
instrument. These are the Trigger Out and the Trigger In
connectors.
LAN Interface
Selecting a LAN Network
For the purposes of this guide, a private (isolated) LAN network
is defined as a network configuration in which instrument
access is a direct connection between the computer and the
instrument, or to multiple instruments connected via a
dedicated router or switch. A site (company-wide) LAN is
defined as a network in which instrument access is available to
NOTE
There are release levers on both sides of the quad-adapter for removing it
from the optical inputs.
release
lever
release
lever
NOTE
Always place the dust cap on unused connector interfaces.
You can use the quad-adapter dust caps to protect the four power meter
inputs and the rear of the quad-adapter, for example, when fibers are
attached.
CAUTION
The Trigger In, see Figure 6, is a TTL input. A maximum of 5 V can be
applied as an external voltage to this input connector.
The Trigger Output, see Figure 6, is the only output BNC connector.
This is a TTL output. Do not apply an external voltage to this
connector.