Technical data

Understanding Your Agilent ChemStation 165
Automation
8
Sequence Parameters
Sequence Parameters
The Sequence Parameters dialog box contains information common to all sample
vials in a sequence. Use this dialog box to:
• select the data directory using the Path combo box, and enter information
about the operator name (the operator name entered in the access level
dialog box is shown), and
• specify how the sequence processing should be done by choosing particular
part of Methods and Run parameters.
For example, you can choose to either:
• execute the run-time checklist,
• do acquisition only, or
• do reprocessing only - for data acquired till ChemStation Rev. B.01.03. - for
data acquired with option Unique Folder Creation OFF
If the reprocess option is selected, you have the choice to use the sample data
defined when the sample was originally analyzed, or by activating the Use
Sequence Table information check box, you can use updated sample data by
entering new data in the sequence table:
• specify what happens when the sequence is finished using the shutdown
parameters, and
• specify if the barcodes should be used in the sequence and how to handle a
barcode mismatch, assuming that a barcode reader is installed on the
system.
NOTE
Sequence data acquired with ChemStation revisions up to B.01.03 or acquired using the
options Unique folder Creation OFF need to be reprocessed using the reprocess option in
the Method and Run Control view.
Sequence data acquired with ChemStation revisions B.02.01 and higher need to be
reprocessed using the reprocess option in the Data Analysis Navigation table.