User`s manual

320 Chapter 9
O:\Manuals\E6380A_Progguid\Book\Errormsg.fm
Error Messages
Numbered HP-IB Error Descriptions
Example 9-104 Error -420
Query UNTERMINATED
Indicates that a condition causing an UNTERMINATED Query error
occurred (see IEEE 488.2, 6.3.2.2.). For example, the device was
addressed to talk and an incomplete program message was received.
This message usually appears when trying to access a measurement
that is not active. For example, you cannot query the TX Frequency
measurement when the TX Freq Error measurement is displayed.
Example 9-105 Error -430
Query DEADLOCKED
Indicates that a condition causing a DEADLOCKED Query error
occurred (see
IEEE 488.2, 6.3.1.7). For example, both input buffer and output buffer
are full and the device cannot continue.
Example 9-106 Error -440
Query UNTERMINATED after indefinite response
Indicates that a query was received in the same program message after
a query requesting an indefinite response was executed (see IEEE
488.2, 6.5.7.5.7).
Example 9-107 Error -606
Update of Input Module Relay Switch Count file failed.
Indicates that the Test Set was not able to update the Input Module
Relay Switch Count EEPROM file with the current switch count data
from the non-volatile RAM switch count array. This error is most
probably generated as a result of a hardware error or failure. Refer to
the Test Set’s Assembly Level Repair for diagnostic information.
Example 9-108 Error -607
Checksum of Non-Volatile RAM Relay Count data bad.
Indicates that the Test Set was not able to generate the proper
checksum for the Input Module Relay Switch Count data from the
non-volatile RAM switch count array. This error is most probably
generated as a result of a hardware error or failure. Refer to the Test
Set’s for diagnostic information.