User`s manual

240 Chapter 8
O:\Manuals\E6380A_Progguid\Book\Ibasic.fm
IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
8. Press DONE to return to the Config screen.
9. Press DONE to return to the Terminal screen.
10.Press MAIN to return to the Main screen.
11.Press EXIT ADVLINK to exit.
Terminal Configuration
Terminals typically have a DB-25 (male) connector. Set the terminal for
DEC VT-100 ANSI emulation. Many ASCII terminals will also function
properly.
To set up the terminal, use the field settings found in “Setting Up HP
AdvanceLink (HP 68333F Version B.02.00) on your PC” on page 238.
As a minimum, make sure the terminal’s basic setup information
matches the fields on the Test Set’s I/O CONFIGURE screen (refer to
Table 8-2 on page 233 for recommended settings).