User`s manual

Chapter 8 237
IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
3. To select a different communications port, enter the following numbers:
• 20: COM1
• 21: COM2
• 22: COM3
• 23: COM4
4. Enter the number 24 to save changes, to make the new configuration your
default, and to exit LINE SETTINGS.
5. Press Alt+S for the SETUP MENU.
6. Enter the number 1 for MODEM SETUP.
7. Enter the number 1 for the Modem init string.
8. Press Enter to set a null string.
9. Press Esc to exit MODEM SETUP back to the SETUP MENU.
10.Enter the number 2 for TERMINAL SETUP.
11.Terminal emulation: VT-100
•Duplex: FULL
•Flow Control: XON/XOFF
• CR translation (in): CR
• CR translation (out): CR
• BS translation: NON-DEST
•BS key definition: BS
•Line wrap: ON
• Scroll: ON
•Break length (ms): 350
• Enquiry (CNTL-E): OFF
12.Press Esc to exit Terminal Setup back to the Setup Menu.
13.Enter the number 4 for General Setup.
• Translate Table: OFF
• Alarm sound: OFF
•Alarm time (secs): 1
• Aborted downloads: KEEP
14.Press Esc to exit General Setup back to the Setup Menu.
15.On the Setup Menu, press S to save your entries.
16.Press Esc to exit the Setup Menu.
17.Press Alt+X to exit ProComm back to MS-DOS.